The lack of for example, support adjustability, wall thickness adjustability, print speed, etc. The software is improving and works very well for certain prints, but is overall not matching what the hardware is capable off. Even any defect cartridge is getting replaced under warranty, it needs a long term solution. The cartridges have been troublesome (as you can see in my other posts). There were a few little issues, but any needed replacement part was covered under warranty. The hardware of my CubeX has been holding up well. See my other post about the heated printbed from GRM products. For ABS printing, I highly recommend the aftermarked heated printbed for the CubeX. I will keep adding to this review or write a new one once I have done some ABS printing and more multicolor stuff.Īfter trying several ABS prints, I find that without a heated printbed, ABS printing is quite limited due to exessive warping of the ABS material.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |